Note: If you experience any issues with the lights not working and suspect an issue with a
component, please try a different port on the expansion board to verify where the fault lies
(with the light or expansion board). To correct any issues with expansion board ports, please
view the section addressing expansion board issues on our
online troubleshooting guide.
14.)
Disconnect the top floor from the rest of the building, then from the backside of the floor,
locate the Strip Light we threaded down the roof of the top level. Pull it down and using it’s
adhesive backing, stick the Strip Light to the ceiling in the following position.
Summary of Contents for 10270
