INSTALLATION & SERVICE MANUAL – FLEXSTEP V2– UK VERSION
1.7
Liftup A/S
Hagensvej 21| DK-9530 Støvring | Denmark |
T:
+45 96 86 30 20 |
M:
[email protected] | www.liftup.dk | CVR DK-1015 3964
43
6
Service mode
6.1
How to set the System into Service Mode.
To set the system into service mode, do as following:
1.
Push emergency stop button.
2.
A) Push and hold two buttons,
while B) releasing the
emergency stop button.
Hold the two buttons for 15
sec.
Use one of the following combinations: Push and hold 2 buttons, and release the
emergency button, and hold the buttons for 15 seconds.
In service mode the system needs to have the ramp lock switch and the vertical Safety
Barrier Switch. In this mode the auto return function is disabled, so is the top stop and
the stair stop.
To leave service mode: Push the emergency stop button,
Push and hold 2 buttons, and
release the emergency button, and hold the buttons for 15 seconds.
6.2
Features in Service Mode NOT CALIBRATED
NOTE 1: Be careful not to travel with the platform higher than 1250 mm.
This can happen in service mode if not calibrated.
Disconnect one of the Actuator on the control Unit. Now the lift is travelling on 3
Actuators (Handy during installation or in case of changing an actuator)
NOTE 2: As the FlexStep is not calibrated, the actuators are not synchronized between
each other (the platform will therefore not stay parallel to the floor).
NOTE 3: Be careful not to brake the E-chain, disconnect it from the RH Side wall profile
is necessary
6.3
Features in Service Mode CALIBRATED
When the system is in service mode, different kind of features are available, see following:
1.
It is possible to set virtual top stops. (see 0)
2.
All four actuators can be moved by pushing the “lift down” or “lift up”.
3.
By pushing “stairs” on the call station only master actuator will move up.
1)
2B)
2A)
