6
(13)
inDOMO HP
- Platform lift
FINAL TESTS
IM.TEC.028.EN_rev.10.2
- November 2015
All rights reserved
iii. command the descent to the lowest floor;
iv. the car speed will exceed the standard and the
block valve will block the descent
;
v. send the lift upwards, to unblock the valve;
vi. refresh.
2.9
OVERLOAD MANOSTAT
Check the efficiency of the overload manostat with a fully loaded car:
i.
send the lift to the lowest stop and enter the car;
ii.
make sure the lift does not respond to commands from inside and outside the car
.
iii. refresh.
2.10 ASCENT AND DESCENT SPEED
Check the car speed with a fully loaded car:
i.
measure the distance between two floors (meters);
ii. from the landing, send the car to the upper floor and notice the travel time (seconds);
iii. repeat the same downwards;
iv. calculate the value “distance (m) / time (s)”;
v.
the speed cannot exceed 0,15 m/s
;
vi. refresh.
FOR EITHER FULLY LOADED OR EMPTY CAR
2.11 STOP PRECISION
Check the stop precision (either fully loaded or empty car):
i.
use the landing operation panel for commands;
ii. with a loaded car, command an upwards travel, letting the lift stop by itself;
iii. open the landing door and (without entering the car) measure the vertical gap between the car doorstep and the
landing level;
iv. repeat the same procedure in case of any other stops (upwards);
v. repeat the same procedure fo all the stops (downwards);
vi. repeat upwards and downards with an empty car;
vii.
maximum acceptable gap in each case: 10 mm under or above the landing
.
EMPTY CAR
2.12 SAFETY SPACE IN PIT
Check the safety space in the pit and the mechanical resistance of the safe-pit with a fully loaded car::
i.
bring the car to the upper stop;
ii. open the landing door and insert the safe-pit device;
iii. Close the door and, by pushing the emergency button, make the car descend till it touches the safe-pit device;
iv. open the lowest landing door and (without accessing the pit) make sure the car is propped correctly,
the minimum
free height being 500 mm
;
v. bring the car to the upper floor and make sure
the pit prop and the fixing nave not been damaged
;
vi. refresh.
