10
(13)
inDOMO HP
- Platform lift
FINAL TESTS
IM.TEC.028.EN_rev.10.2
- November 2015
All rights reserved
2.31 PHOTOCELLS OR LIGHT BARRIERS (if any)
To check these devices proceed as follows:
CAR WITHOUT DOORS
With the car moving, catch the ray of a photocell (light barrier);
the lift will stop and remain stationary until the removal
of the obstacle
. Then send the car upwards.
CAR WITH DOORS
when the car is stationary at a stop while the doors are closing, catch the ray of a photocell (light barrier),
the car doors
will open and remail open until the removal of the obstacle
.
2.32 BUTTON ENABLING KEY (optional)
To test the key proceed as follows:
i.
in the car, without commuting to the enabling key, try to send the car upwards and downwards: the lift will not
respond;
ii. press the alarm button to activate the siren;
iii. commute to the key and repeat the same operations: the lift will start moving regularly;
iv. commute to the landing key and repeat from each floor.
2.33 CONTROL CABINET
Check the following conditions:
i.
the control cabinet is located in a suitable room, protected from bad weather conditions and humidity, and can keep
the constant temperature comprised between 5 and 40 °C;
ii. the area in front of the cabinet door is clean, and its width and height are suffucient for a safe access;
iii. a relevant lighting is available, to ensure a perfect visibility and component identification inside the cabinet;
iv. the hoses and electrical wires connected to the cabinet are adequately protected from damages, and inspectable.
2.34 SIGNAGE
Check the correct application of the following plates and signs
:
i.
in the pit (access might be dangerous without safety devices);
ii. on the car roof (not bearing surface);
iii. on the control cabinet (electrical hazard, emergency operation instructions);
iv. beside the main supply switch (operation mode);
v. beside the red emergency descent button (for an easy identification);
vi. in the car (duty load, capacity, name of manufacturer, emergency instructions for the COP in case of power cuts);
vii. close to the outer alarm system of the lift (to explain its function) .
2.35 NOISE EMISSION
Verify that the sound pressure emission does not exceeds the maximum level in the following areas (± 3 dB(A))
:
i.
inside of the car: 60 dB(A);
ii. by the landing area, at a distance of 1 metre from the landing door: 55 dB(A);
iii. in front of the machine room cabinet , at a distance of 1 metre: 55 dB(A);
