5
2
Attach sensor wires to electrodes
1. Remove four electrodes from the electrode pouch.
2. Fold over the open end of the pouch to protect the unused electrodes
from drying out.
Note:
Electrodes should be stored at room temperature.
3. Snap an electrode onto each of the
four lead wires that are attached to
the sensor.
4. Using the peel tab, peel each electrode
from the backing and discard the backing.
4
Place electrodes on your body
4
1. Place each color coded electrode on healthy, non-irritated skin according
to the diagram on the previous page (pg.1).
Do not apply electrodes to skin that has an open cut or is already irritated.
If skin is cut or irritated, apply the electrode in close proximity to the required
location on clean, non-irritated skin.
2. Apply each electrode by gently pressing down on the center and moving
toward the edge in a circular motion to assure firm attachment to the
skin.
Place the white lead wire with electrode 3 fingers width below the
midpoint of the collarbone.
Place the red lead wire with electrode above your last rib on the left side
aligned with the midpoint of the collarbone.
Place the black lead wire with electrode on your left side, about 4-5 inches
horizontally to the left of the red electrode, in line with the center of your
armpit.
Place the green lead wire with electrode on the left side of the abdomen.
Note:
If necessary, lift the left breast to get the proper electrode placement
of the red and black electrodes.
How to record a Manual Event
You can record a manual event if you experience dizziness, chest pain, or
other symptom(s).
Initiate recording with sensor or Monitor.
Monitor Layout
Press the sensor side buttons simultaneously and release
the buttons when there is a beep.
OR
Select “Record Event” at the bottom of Monitor homescreen.
Select “Yes” to send recording, or “No” to cancel.
Choose your symptoms and activities on Monitor Screen
1. Choose the symptom(s) you felt, or select “No Symptoms”.
2. Select “Next” at the bottom of the screen.
3. Choose the activity you were engaged in.
4. Select “Send” to send the manual event.
3
4
On/Off Button
Monitor Charge Port
Battery Indicator shows the level of battery
charge and if the Monitor is in charge mode.
Emergency Call Button
(call can be canceled within 10 sec.)
Icon alerts may appear on Monitor homescreen.
Alerts will disappear once issue has been resolved.
