40
41
Shelf Installation
25
1001693
#2 Screwdriver (1)
25a
Hardware Bags: 1009125
Screwdriver
CN
(49)
Insert Shelf Brackets (BE and BF) into notches in any Wall
Support Channel. Place the Shelves on brackets and secure
with #10 screws (CN) and #10 Washers (CK). Use the 14” Shelf
Brackets with 14” shelves, and 10” Brackets with 10” shelves.
Step 23 Hardware
25b
Install a Back Shelf Bracket (EB) to any 10” or 14” Shelf with a #10 screw (CN). Line up the Bracket so
that it will connect to the wall in between grooves. Attach it to the bottom of the shelf. Then screw the
Bracket into the wall.
Insert Brackets into the inside
set of slots on the Wall Channels.
Otherwise Brackets will be too
far apart to support shelves.
25c
Shelves may also be installed in between trusses to provide overhead storage. Rest a shelf (either 10”
or 14”) between two trusses. Attach shelf to Truss Channels (AM) through slotted holes in channels.
CK
(28)
CK
CN
BE or BF
Note: This is an interior upward view.
CN
CN
Pegboard Installation
26
26a
Hardware Bags: 1009109
Screwdriver
Step 26 Hardware
CJ
(10)
CJ
Achoring the Shed
27
27a
After assembling your shed, you may want to anchor it to the ground. It can be anchored through
the Floor Brackets (FA) you attached to each Wall Support. Consult your local hardware store for
suggestions on the best hardware to use for anchoring your shed. Whatever you use, the diameter of any
screw or bolt cannot exceed 3/8”.
Adjust Door Spacing
28
28a
You may need to move the tops and/or bottoms of the doors to eliminate uneven gaps. Loosen the Carriage
Bolts at the four corners of the door frame. Loosen all screws in the left and right Door Hinges by a half a
turn. Move Doors until gaps are even. Re-tighten the four Carriage Bolts. Re-tighten the screws in the left
and right Door Hinges.
Insert Anchoring Hardware
through the Floor Brackets
(FA) attached to the bottom of
each Wall Support.
FA
Alternate Shelf Location
Loosen these Carriage
Bolts before adjusting
Doors.
Loosen the Screws
in both Hinges before
adjusting Doors.
The Pegboard Strips are
screwed directly into the
plastic (they do not need
to line up with any screw
bosses) and can be installed
anywhere on any wall.
Use a Level, and position both 16” Pegboard Strips (BA)
in the desired locations. Screw the Pegboards to the wall
using #10 x 3/4” screws (CJ).
See Note
.
Be sure that the Pegboard Strip is
level before inserting screws.
The shelves fi t length wise
inbetween the Trusses.
CN
EB
