LSCT
Maintenance manual
Item N° 326617
Revision A
Date 25/06/2015
Page 58 of 93
SEAT WIDTH ADJUSTMENT (1/2) :
Dismantling:
1. Place the chair in a slightly standing
position (take out the standing actuator by
about 50mm).
2. Remove the seat cushion
3. Remove the backrest cover.
4. Detach the backrest straps
5. Remove the six screws holding the seat
plates (Careful not to lose the spacers
located at the level of the two rear
screws). (See figure 138)
6. Untighten the 2 screws of the headrest /
harness crossbar if installed on the
wheelchair. (See figure 139)
7. Remove the four on the upper backrest
cross beam (only 2 screws for sizes 36,
40, 44). (See figure 139)
8. Remove the 8 screws on the lower
backrest cross beam. (See figure 139)
9. Pull out or push in the seat and the
backrest to obtain the desired width. (if
necessary, modify the wiring (see section
«Chair wiring»)). (See figure 140)
SETTINGS:
T36
T40
T44
T48
Figure 138
Figure 139
Figure 140
