755-00002 Rev R
LifePort Kidney Transporter Operator’s Manual
16
Load LifePort Kidney Transporter Disposable Perfusion Circuit
Once you have verified the kidney and checked for any contraindications against proceeding, use these
instructions to load the LifePort Kidney Transporter Disposable Perfusion Circuit into LifePort Kidney
Transporter.
This procedure can also be found in the LifePort Kidney
Transporter Disposable Perfusion Circuit Instructions for Use.
WARNING:
Where noted, perform the following procedure on an aseptic field using standard aseptic
technique.
1.
Using standard aseptic technique
, prepare a sterile field and introduce all necessary materials.
2.
Using standard aseptic technique
, remove Outer Perfusion Circuit Lid and Inner Perfusion Circuit Lid and
place onto the sterile field.
3.
Using standard aseptic technique
, remove the
Kidney Cradle and set aside within the sterile field.
4.
Using standard aseptic technique
, fill
LifePort Kidney Transporter Disposable Perfusion Circuit with 1 Liter
chilled (1–8°C) perfusate.
5. Using standard aseptic technique
, replace and secure Inner Perfusion Circuit Lid followed by the Outer
Perfusion Circuit Lid.
WARNING:
LifePort Kidney Transporter Disposable Perfusion Circuit inner surfaces are considered
sterile, while outer surfaces are not considered sterile.
6. Place Perfusion Circuit into LifePort Kidney Transporter.
7. Position the Tubeframe upright, perpendicular to the Pump Deck. Insert the hinges into the receivers
before rotating flat onto the
Pump Deck.
8. Open the Pumphead Raceway and stretch the Pump Tubing Loop around the Infusion Pump. Close and
latch the Pumphead Raceway.
CAUTION:
Do not use any tools or implements to strech the Pump Tubing Loop onto the Infusion
Pump.
9. Rotate the Pump Deck Locking Arm 90 degrees until it clicks into place.
10. Connect the Pressure Sensor Cable from the Pump Deck to the Pressure Sensor Connector on the
Tubeframe.
11. Press and hold the
POWER
button until you hear an audible beep, then release.
12. Press the
WASH
button to enter Wash Mode.
