Assembly Figure 6
FIGURE 6
Tools Needed:
Philips Screw driver: 2E3E
6mm Allen wrench: 0J3V
Note:
Part #2D41 rear cover will
need to be removed before console
mast can go on.
Note:
Be careful not to pinch any
wires.
¾
Locate bag labeled
Figure 6
.
¾
Using a Philips screw driver to
remove Qty. five M5x12 screws
from the rear cover and then
place the screws and cover down
in a secure place.
¾
Locate console mast and slide
console mast into upper support
tube assembly, make sure
computer cable wire slides down
straight and does not get
pinched.
¾
Connect the computer cable wire
coming from the console mast to
the upper support tube middle
wire on the left side of the
machine.
¾
(See Figure 6)
Using Qty. three
M3x1.25-50 bolts thread those
through the console mast and
using a 6mm Allen wrench to
tighten them securely.
¾
Grab the rear cover and refasten
the cover to the machine with a
Philips screw driver using the
same Qty. five M5x12 Screws.
M3x12
Screws
Rear
Cover
11
|
P a g e
Summary of Contents for LC-CD600
Page 2: ...2 P a g e...
Page 29: ...2 29 P a g e...
