Assembly Figure 1
Getting Started
The LifeCore Fitness LC-CD600 Elliptical will require some assembly. Unpack the box in a clear
location, remove all packaged parts from the box and lay each part out on the floor. Double
check all packaging material for missing pieces, do not dispose of any packing material until
assembly is complete and unit is working properly. The final location of the machine should be
placed on a clean level surface near an electrical outlet.
Hardware Bags -
Locate all hardware bags for assembly. Bags will be Labeled
Figure 1
through
Figure 8
. Tools have been provided to assist with product assembly.
If you are missing any parts, assembly bags or need assistance with assembly please call
LifeCore Fitness at 1-888-815-5553.
FIGURE 1
Tools Needed:
6mm Allen wrench: 0J3V
Note:
It is recommended that two
adults help during this step. One
person holds the upper support tube
assembly while another connects the
upper support tube wires to the lower
wire cables.
Note:
Be careful not pinch upper
support tube wire, or lower wire cable
while sliding upper support tube
assembly into place.
¾
Locate bag labeled
Figure 1
.
¾
Locate upper support tube
assembly.
¾
Before attaching upper support tube
to the main frame, connect upper
support tube wire to lower wire
cable.
2XKB Connects to 2XJA
(See Parts Diagram for More Detail)
¾
(See Figure 1)
Secure upper
support tube assembly to frame
using Qty. eight M8X1.25-12mm
hex head bolts and Qty. eight 8x16
washers on right side. Using 6mm
Allen wrench, tighten bolts secure.
Slide Black rubber boot over bolts.
¾
Repeat same steps for left side.
6
|
P a g e
Summary of Contents for LC-CD600
Page 2: ...2 P a g e...
Page 29: ...2 29 P a g e...
