6
OFF
230V
OFF
1
3
ON
ON
230V
2
OF
F
230V
OFF
230V
OFF
1
2
ON
ON
230V
Energy Saving
1
2
1
2
In order to optimize electrical consumption
we introduced the ES function.
After 10’ from the central
programmation the Leds of the front
panel will turn off and the keyboardwill
be deactivated.
To re-activate the keyboard turn the
central unit off and on again
2.2 RUN PROGRAMMATION AND SHUTTERS OFFSET
will first turn on and then they will blink.
As soon as this process is done the two green Leds will start blinking , while the two red Leds will stay on
If the result is not satisfying it is possible to execute a manual programmation to define different
offsets.Refer to chapter n°7.
a) Position the shutters at a 45° angle.
b) Press the button for 5” , the 5 Leds
c) Press the gate will execute this sequence :
- Closing Shutter 2,
- Closing Shutte 1,
- Opening Shutter 1, with offset
- Opening Shutter 2,
- Closing Shutter 2, with offset
- Closing Shutter 1.
N.B. In case only one motor is being used connect it with the n°35 and n°36 clamps.
Make sure to fix the mechanical limit switches of opening and closing of the automation
When the programmation is done for 10 minutes the button can be used as a STEP command
N.B.
In order to totally reset the unit , before giving power, press and keep pushed the button, release
after the central unit.
2 CENTRAL UNIT PROGRAMMATION
2.1 TOTAL RESET
ATTENTION
START
START
START
START
To optimize energy consumption,
we have introduced the Energy
Saving function. After 10 minutes
from the control unit setup, the front
panel LEDs turn off and the use of
the keyboard is inhibited. To
reactivate it, it is necessary to switch
the control unit off and on again.
CONTROL UNIT SETUP
Power off the system, hold the start button, power on again and release the start button once the
red leds come on.
PROGRAMMING THE TRAVEL AND THE LEAVES’ SHIFT
N.B. If only one motor is used, connect it to terminals 35 - 36.
Make sure you have fixed the mechanical opening and closing limit switches of the automation.
Place the leaves at 45°
Press and hold down the START button for
5 seconds until all 5 red LED’S blink.
Press START, the automation performs in sequence:
- closure leaf 2;
- closure leaf 1;
- opening leaf 1, with phase shift;
- opening leaf 2;
- closure leaf 2, with phase shift;
- closure leaf 1.
Once programming is complete, the two green LEDs will flash, while the two red LEDs will turn on with
a steady light.
The START key at the end of programming, for 10 minutes can be used as a STEP command
If the result is not satisfactory, it is possible to carry out a manual programming to define the different
phase shifts. See chapter No. 7.
LAG
lag;
lag;
PHASE LAG
PROGRAMMING THE TRAVEL AND PHASE LAG
lags
