The standardized DMX-Signal is based on industrie´s RS485 Interface. It is designed for
maximum lengths up to 1200m. This length is under condition in theatre or studio normally
not possible. As a result of internal tests we recommend a maximum length of 200m (
only
DMX, 5PIN
). A maximum of 32 DMX receiver can be connected to one DMX transmitter. If
more devices should be connected a splitbox must be used.
The last device in a row should be terminated with a 470 Ohm resistor. The maximum lin
length must not exceed 80 m (DataPower, 4pin) because of the voltage drop.
Cabling without Splitbox:
Connect the Mix4-6 with the devices directly via a 4pin DataPower cable. Connect them in
a row (daisy chain). Observe the maximum load of 120W. The motoryoke has no output
connector, so only one motoryoke can be connected without a splitbox!
Mix 4-6 Rev.: 1.02
7
Mix4-6
IN
OUT
Mains
DataPower
cable 4pin
