Handling / Programming
Now, the DMX-adresses of the devices have to be adapted to the panel. Program the
device-addresses like indicated on the Mix4-6:
The focus-adresses are automatically okay, because on the yoke you only have to set the
first adress. All others follow. The startadress of the motoryoke is programmed in menu
P01. (See also motoryoke manual).
For additional devices (e.g. dimmer-shutter or color changer) you can use the adresses 8
to 13. These are controllable with the 6 faders.
Very important:
The menu P27 at the motoyoke must be set to 1. It determines that 2 DMX-channels for
the PAN and TILT speed is used (Normally 1 for both speeds). See also motoryoke
manual. Is this value not set to 1, the motoryokes are not controllable from this board.
Now everything should be programmed correctly. With the unit-buttons the desired
motoryoke system can be selected. The corresponding LED lights. With the Joystick, the
motoryoke can be moved.
The focus-buttons control the focus unit. The LED bargraph indicates the position
approximately. It is not a correct indicator for the focus position.
The 6 faders on the right hand side represent the indicated DMX channels. With the flash
buttons you can set the DMX value to maximum.
Mix 4-6 Rev.: 1.02
9
Motoryoke
Startadress
1
1
2
21
3
31
4
41
