The motoryoke must be kept
dry
. In case of water condensation a waiting period of up to
2 hours is necessary until acclimatisation is reached.
If
knobs
for manual moving are mounted, they can only be used if the motoryoke is in
power off condition. If the device is switched on and the knobs are rotated manually the
motors and/or gearboxes can be damaged.
Make sure to mount the payload in the weight
balancing point
. The motoryoke must only
be operated with balanced tilt, otherwise the motor and/or gearbox can be damaged.
Observe the right cabling. The
cable-loop
must be wide enough and the correct cable-
route must be observed. The cables with the safety belt are last fixed left beside the safety
hole of the motoryoke.
Wrong routed cables can lead to defective cables, because of the mechanic and thermic
influence!
Check the complete
pan moving range
before starting the equipment by turning by hand!
Too short cable loops can block the pan axis!
Never use the standard DMX-IN and the special control IN at the
same
time. Only one
can be used!
When it has to be assumed that a
safe operation
is no longer possible, the equipment
must be switched off immediately and be
secured against unintended
operation.
This is the case when
–
the equipment shows visible damages
–
the equipment is no longer functional
–
parts of the equipment are loose or slackened
–
connecting lines show visible damages
Attention:
Before
starting the equipment the user must check the usefulness of the device for its
intended use.
We reject every
liability
:
–
Damages and indirect damages or every kind of costs, which result from the use of
Licht-Technik products.
–
Any damages which result from negligence, improper use and setup, wrong setting into
operation and use, ignoring of valid safety regulations, unsuitable use, bad
maintenance of Licht-Technik products.
8
Motoryoke YipMan1 V4.58 Rev 1.00
