TILT – axis moving range
Basically:
The TILT-axle is the axle which moves the lamp
vertically
.
Normally the factory presettings are
suitable
and nothing must be set. The lamp can be
moved from vertically down to a few degrees on the top.
The 0-degree position represents the vertical position of the mounting socket. From this
position a
positive
moving range and a
negative
moving range is defined. The positive
range is much smaller than the negative range. This is the reason why it can not be
determined where the 50% DMX position is.
TILT moving range is in opposite to the PAN moving range asymmetric. It is set in two
menus. (P12, page 25 and P13 page 26).
Do not forget to press
two
times the
OK
key to get back to working level after
programming.
Check the complete new moving range with the
DMX-signal.
Caution
!!
Check the entire
moving range
of the lamp:
The lamp-manufacturer specify
minimum distances
to inflammable materials. Never fall
below the minimum distance in no position of the lamp!
Check that the
motoryoke
will not be illuminated when lamp is on top position.
Make sure that no cable will be
broken
,
bended
,
stretched
or
damaged
anyhow by
reason of turning the motoryoke!
Headlights generally must
not
be operated with the ignition electronic on the top. Observe
the specifications of the lamp manufacturer!
Motoryoke YipMan1 V4.58 Rev 1.00 17
+20°
0°- position
-90°
TILT-plus moving range
TILT-minus moving range
Total moving range
