Appendix D
Appendix D
D-5
The (Outputs..) Command
(Outputs..)
is used to configure the items pertaining to data output, including the
bandwidth, delay time, DACs (digital to analog convertors), and the RS-232 port. The actual
RS-232 output uses the
(Data..)
record described in Table 2.
Table 1: The Outputs Command
Command
Subcommands
Remarks
(BW {5 | 10 | 20})
Sets instrument bandwidth to 5, 10, or 20 Hz.
(
Delay
{int})
Output delay interval (0 to 32), where each
interval is 1/152 seconds. This is added to the
230 ms system delay.
(Outputs
(Source
{List
a
})
)
The variable that drives the DACs (digital to
analog converters)
(Dac1
(Dac2
(Zero
{float})
)
Value that corresponds to 0 Volts output
(Full
{float})
Value that corresponds to 5 Volts output
(SDM
(Address
{int})
)
SDM address (0 thru 14).
Summary of Contents for LI-7500
