LG VK9821 Series, Owner'S Manual

Page: 17 / 32

17
How to use
How to add water, how to replace and clean the microfiber cloth
How to add water
• When the “SUPPLY WATER” light is turned in the LED display window
of the nozzle, stop operating the steam cleaning vacuum tool and unplug
the power.
• Open the water hole cap of the nozzle and use the measuring cup
(water supply cup)to pour the water. (Appropriate amount: 250ml)
• Lock the water hole cap of the vacuum tool in the arrow direction as
shown in the picture.
- Turn the cap to the right direction until you hear a clicking sound.
• After turning on the power again, steam cleaning can be recommenced
shortly after the "STEAM" lamp is once again activated by pressing the
steam on/off switch and holding down the safety trigger.
- The “SUPPLY WATER” LED will be turned off and the "STEAM" led
will tun on approximately 1 minute after the water has been refilled
and the Steam function reactivated. Make sure that the steam
vacuum tool and the hose handle are flat on the floor when refilling
with water so that the reservoir cannot tip over.
How to replace and clean the microfiber cloth
When replacing the microfiber cloth, always make
sure the power is turned off.
• Detach the cloth board from the steam cleaning
vacuum tool and replace the microfiber cloth.
Attach the white side of the microfiber cloth on the
cloth board on the bottom surface of the cleaner.
• Reuse the dirty cloth by cleaning it with clean water,
soap, detergent etc. and then by completely drying
the cloth in the shade.
CAUTION
• If you do not completely remove the moisture
when using the microfiber cloth, it can cause
electric shock and damage the main unit.
• Attach the microfiber cloth so that the vacuum
hole of the steam cleaning vacuum tool is not
covered.
• The cloth can get wet faster depending on how
the steam vacuum tool is used and the time. At
this time, when you replace the cloth, you can
clean with a dry cloth.
STEAM SUPPLY
WATER
STEAM SUPPLY
WATER
CAUTION
• To reduce the foreign particles formed inside the water tank as
much as possible, use demineralised or filtered water.
• When filling with water, you must stop operating the steam cleaning
vacuum tool and unplug the power.
• When filling with water, lay the hose handle on the floor and fill with
water.