UNPACK ING & INSTALLING
BEFORE USE
By following the basic steps on these two pages you will be able to quickly check that your oven is operating correctly.
Please pay particular attention to the guidelines on where to install your oven. When unpacking your oven make sure
you remove all accessories and packing materials. Check to make sure that your oven has not been damaged during
shipping.
1
2
the edge of the surface to prevent tipping.
An exhaust outlet is located on the bottom and side of the oven.
Blocking the outlet can damage the oven.
If you use the microwave oven in an enclosed space or cupboard,
lower performance and reduced service life. If possible, please use the
microwave oven in the counter top condition.
NOTE
•
THIS OVEN SHOULD NOT BE USED FOR COMMERCIAL CATERING PURPOSES. DO NOT USE THIS OVEN IN A BUILT IN APPLICATION.
3
Plug your oven into a standard household socket. Make sure your oven is the only appliance connected to the socket.
If your oven does not operate properly, unplug it from the electrical socket and then plug it back in.
4
Fill a
microwave safe container
with 300 ml (1/2 pint) of water.
Place on the glass tray and close the oven door.
If you have any doubts about what type of container to use
please refer to Microwave-safe utensils.
Open your oven door by pulling the door handle. Place the rotating ring inside the oven and place the glass tray on top.
5
G LASS TRAY
ROTATING RING
TURNTABLE SHAFT
8
BEFORE USE
Mic a Sheet
Mic a Sheet
* Do Not Remove
M ica Sheet
10 cm
5 cm
15 cm
10 cm
NOTE
•
Do not remove the cavity Mica Sheet (silver plate) inside of oven.
The Mica Sheet is there to protect the microwave components from food spatters.
rear ventilation. The front of the oven should be at least 8 cm from
Place the oven on the level location of your choice with more
than 85cm height but make sure there is at least 15 cm of space
on the top and 10 cm at the left & right for proper and 5 cm at the
