LG LNP3021R, Owner'S Manual

Page: 15 / 27

Network IR PTZ Camera Owner’s Manual
10
3.5 Alarm Linkage
Alarm Linkage is the system reaction after an alarm
signal is received. It is to raise watch man’s attention
to handle the event.
The alarm signal comes from Motion Detection
(details in Chapter 3.2) or Alarm Input Device (such as
smoke detector) in the surveillance area.
Alarm Linkage reaction includes Alarm Text Overlay,
Snapshot or triggering alarm output device (such as
alarm bell). Explanations are as follows:
Text Overlay : when alarm is triggered, display alarm
text on screen.
*Acoustic Alarm : when alarm is triggered, make a
warning sound.
*Recording Linkage : when alarm is triggered, start to
record video automatically in SD card.
*Snapshot: when alarm is triggered, take a snapshot
of the alarm event.
*Alarm Output: when alarm is triggered, link to the
alarm output device.
3.5.1 Motion Detection Linkage
2) Check the Linkage Type for motion detection.
For example, if user checks Snapshot, when
alarm is triggered, the system will take a snapshot.
In Settings>Storage>Snapshot interface, user
can set picture format, resolution, interval and
quantity.
3.5.2 Tempering Alarm Linkage
1) Enable Tempering Alarm , and set the tempering
area and sensitivity. The method is the same as
that of Motion Detection.
2) Check Linkage Type.
3) Click “ Save ” to finish setting.
3.5.3 Alarm Input Linkage
The camera supports on/off alarming device.
Picture 3-12 Alarm Input
It is triggered when something abnormal happens.
Abnormality includes Disk Full, Disk Error and Internet
Disconnected.
1) Enable Motion Detection , and set the detection
area and sensitivity. Please refer to Chapter 3.2
Motion Detection for details.
1) Make sure the alarm input device is always
enabled or disabled, and that it is rightly
connected to the alarm input port of camera.
2) Go to Settings>Event>Alarm Input , and select
an alarm input ID from the dropdown list (in
accordance with the alarm input port).
3) Input alarm name, and select “Always Enabled”
or “Always Disabled” from the dropdown list of
alarm type.
4) Click “ Edit ” and set durations at the popup
interface. Check durations and set “ Start Time ”
and “ End Time ”. Check the week day(s) to copy
the setting to the day(s).
5) Check “ Linkage Type ”.
6) Click “ Save ” to finish setting.
3.5.4 Abnormality Linkage