Network IR PTZ Camera Owner’s Manual
6
Day, when alarm inputs, the system will switch to day
mode.
3.1.2.4 Noise Reduction
When there are many noise points caused by
environment and camera lens, Noise Reduction
function can be enabled to adjust images.
Go to
Settings>Camera>Image>Image
Enhancement
, enable 3D Noise Reduction. When
selecting “Disable”, this function will be disabled.
When select “Enable”, user can drag the slide bar to
adjust 3D Noise Reduction Level.
3.1.3 Auxiliary Function
*
Wiper
Wiper is used to clean the dome housing. In the PTZ
control part of the Live View interface, Click
to
start the wiper. Click
again to stop the wiper. The
wiper will stop automatically after 10 brushes. Click
to enable wiper again if necessary.
3.2 Motion Detection
Detect movements in the defined area. Once the
movement exceeds the defined sensitivity, an alarm
will be triggered by Web Client.
Picture 3-3 Motion Detection
3.2.1 Set Area
Motion detection supports full area detection and
maximum 4 user-defined areas.
1) Go
to
Settings>Event>Video Analysis>Motion
Detection
, check “Enable”
2) Click “Edit” and the image will be divided into 16
columns and 12 lines of squares. Click a square
and drag an area from it, then the area will turn
purple and is the motion detection area. A camera
can support maximum 4 areas.
3) Drag the slide bar to adjust Sensitivity.
4) Click “Edit”. On the popup page, check durations
and set start time and end time.
5) Click “Copy” to copy the defined motion detection
time to a certain day or the whole week.
6) Select “Linkage Type”. It is the alarm output
method when an alarm is detected in the defined
area.
3.2.2 Clear Area
Start from an undefined square and draw an area that
contains the defined area, or click the defined squares
one by one to clear setting, or click “Clear” to clear
setting. Save to make settings effective.
3.2.3 Disable Function
To disable this function, uncheck the
checkbox
Enable.
3.3 PTZ Control
The camera is equipped with digital PTZ, which is
suitable for large scope patrol and enlarges view field.
User can control PTZ via the Web Client. In the PTZ
control part of the
Live View
interface, user can
control PTZ manually, as is shown below:
Picture 3-4 PTZ Control
Summary of Contents for LNP3021R
Page 27: ......
