PJL
3-75
LPRINT Commands (Information Pages)
Use these commands to print one of the internal information pages.
@PJL testpage[<CR>]<LF>
The supported
testpage
values are listed in the following table.
For example, to print a menu settings page:
Syntax:
@PJL LPRINTMENUS[<CR>]<LF>
LESCAPECHAR Command
This command modifies the code point of the escape character for the host computer.
The command information is specified by the PORT parameter. The escape character
is mapped to code point 0x1B for each host interface port.
Syntax:
@PJL LESCAPECHAR CHAR=
byte
PORT=
port
[<CR>]<LF>
CHAR
parameter
The
byte
value for the CHAR parameter is the code point of the ASCII character
used for the escape character.
For example, at the factory, the printer uses 0x1B (character <Esc>) for the
escape character. If CHAR = 65 is specified with this command, the printer uses
0x41 (character ‘A’) as the escape character for the host interface port specified
via the PORT parameter.
Table 3-20: LPRINT testpage Commands
testpage Value
Description
LPRINTDIRECTORY
Prints both the flash and disk directory listings. If neither flash
memory or a disk is installed, the command is ignored.
LPRINTTESTPAGE
Prints the test page.
LPRINTMENUS
Prints the menu settings page.
LPRINTPCLFONTS
Prints the PCL font listing.
LPRINTPSFONTS
Prints the PostScript font listing.
