Setting Top
‑
Of
‑
Form for continuous forms in pull mode
1
Plug the printer power cord to a properly grounded electrical outlet, and then press
Start/Stop
.
Note:
The Paper Out light blinks if no paper is loaded.
2
Move the paper select lever down to the position.
3
Load continuous form paper on the pull tractor feed pins.
4
Open the control panel cover to access layer 2.
Power
Set TOF
LineFeed
Macro
Setup
Pitch
1
0
15
17
2
0
2
4
1
2
3
4
Micro
Micro
12
Lock
5
Press any paper movement button (
Micro
,
Micro
, or
LineFeed
) to move the paper to the Top
‑
Of
‑
Form position.
Note:
Use the second sheet of continuous forms paper to set Top
‑
Of
‑
Form.
6
Press
Set TOF
to set and save Top
‑
Of
‑
Form.
7
Close the control panel cover.
Note:
Top
‑
Of
‑
Form is not saved when the printer is unplugged from the electrical outlet or runs out of paper
when the printer is in pull tractor mode.
8
Press
Start/Stop
to set the printer online.
Setting Top
‑
Of
‑
Form for a cut form or an envelope
Top
‑
Of
‑
Form can range from minus one inch to plus 22 inches from the top of a cut form.
1
Clear the paper path.
The Paper Out light blinks if no paper is loaded. If the Paper Out light is off, tear off excess forms, and then press
Load/Unload
. If a single form is loaded, press
FormFeed
to clear the paper path.
2
Move the paper select lever up to the position.
3
Load a cut sheet of paper or an envelope through the manual feeder.
•
If Auto Cut Sheet is set to On, the printer will move the paper or envelope to the current Top
‑
Of
‑
Form.
•
If Auto Cut Sheet is set to Off, press
FormFeed
when the Paper Out light goes off.
Loading paper
41
