71
5.4 Configuring a MarkNet XLe
To enable IPDS printing with the MarkNet XLe several settings must be changed.
Changes to MarkNet XLe settings can only be made using the appropriate network
printer utilities
. For more information on how to change these settings, refer to your
Lexmark network adapter manual, which came with your print server.
•
Network Adapter User's Guide
or
•
Network Adapter Hardware Setup
or
•
MarkNet XLe Setup and Service Guide
5.4.1 Printing a MarkNet XLe Setup Page
Microcode Level
MarkNet XLe
04.130.01 (or greater)
To see the code level, you need to print the setup page. Under the section Network
Card, look for Firmware Revision. The middle number (in this case “130”) is the one
you want to be greater than or equal to.
To print the MarkNet XLe setup page, do the following:
1.
Remove the adapter’s switch cover.
2.
Press the
Test
button until the Test light comes on. The XLe setup page will
print on the attached printer.
3.
Replace the adapter’s switch cover.
For more information, see Lexmark’s
Network Printer Utility Guide
.
If you need to update your MarkNet XLe code level
, contact the Lexmark Technical
Support Center. MarkNet XLe firmware updates are also available from the Lexmark
web site at
http://www.lexmark.com
.
