CAUTION—POTENTIAL INJURY:
When moving the printer, follow these guidelines to avoid personal
injury or printer damage:
•
Make sure that all doors and trays are closed.
•
Turn off the printer, and then unplug the power cord from the electrical outlet.
•
Disconnect all cords and cables from the printer.
•
If the printer has a caster base, then carefully roll it to the new location. Use caution when passing over
thresholds and breaks in flooring.
•
If the printer does not have a caster base but is configured with optional trays, then lift the printer off the
trays. Do not try to lift the printer and the trays at the same time.
•
Always use the handholds on the printer to lift it.
•
Any cart used to move the printer must have a surface able to support the full footprint of the printer.
•
Any cart used to move the hardware options must have a surface able to support the dimensions of the
options.
•
Keep the printer in an upright position.
•
Avoid severe jarring movements.
•
Make sure that your fingers are not under the printer when you set it down.
•
Make sure that there is adequate clearance around the printer.
Note:
Damage to the printer caused by improper moving is not covered by the printer warranty.
Shipping the printer
For shipping instructions, go to
Saving energy and paper
Setting up power saver modes
Eco
‑
Mode
1
From the home screen, touch
Settings
>
Device
>
Power Management
>
Eco
‑
Mode
.
2
Select a setting.
Sleep mode
1
From the home screen, touch
Settings
>
Device
>
Power Management
>
Timeouts
>
Sleep Mode
.
2
Enter the number of minutes the printer stays idle before it enters Sleep mode.
Hibernate mode
1
From the home screen, touch
Settings
>
Device
>
Power Management
>
Timeouts
>
Hibernate Timeout
.
2
Select the amount of time before the printer enters hibernate mode.
Notes:
•
Make sure to wake the printer from hibernate mode before sending a print job.
Maintaining the printer
68
Summary of Contents for C6160
