Lexmark 522n - C Color Laser Printer, Service Manual

Page: 42 / 334

2-14
Service Manual
4520-xxx
89 00 01 The exit sensor in the fuser is activated by a piece of media
indicating there is a piece of media in the machine during
POST.
*Check for media in the exit of the fuser assembly or redrive
assembly. Feed a sheet of paper, and if the same error
occurs after clearing the fuser or the same error occurs
when no media is present, check the exit sensor assembly,
internal fuser assembly cabling, DC fuser cable to the
system board, and the cable connection to J14 on the
system board.
TIP: Turn the printer off, enter the diagnostic tests menu, and
select the base sensor test. Select output sensor and check
the sensor for correct operation.
89 xx 03 The fuser exit sensor did not detect the trailing edge of the
media going through the fuser assembly.
*This failure can be caused by a broken fuser exit sensor
flag.
*This may also be caused by erratic operation of exit sensor
flag or exit sensor or a defective piece of media.
89 xx 04 x1 The fuser exit sensor never actuated from the sheet going
through the fuser before the next page begins feeding.
(x-1=Media Size)
89 xx 07 The narrow media sensor in the fuser was covered by a sheet
of paper when not expected or a piece of media is in the
machine during POST.
*This error can occur when a 202 paper jam has occurred.
*Remove any piece of media that is over the narrow media
sensor.
*Try to feed a piece of paper through the printer (could run
the print test from the diagnostic test menu). If the media
stops over the narrow media sensor again, check the flag
and sensor for correct operation.
89 xx 0B x1 The fuser exit sensor may be bouncing.
*This error can be caused by a failing exit sensor or system
board.
First 6
Bytes Sub
Error Code
Data - Note:
xx can be
any value.
Explanation