Lexicon MC-4, User Manual

Page: 96 / 164

AUDIO CONTROLS
Lexicon
4-4
TILT EQ
–3.0dB to +3.0dB
Controls the amount of tilt equalization applied to the audio
output connectors labeled Front L/R, Center and Subwoofer. This
parameter setting affects the entire frequency spectrum with a
hinge point at 1kHz. As the setting is increased, frequencies
higher than 1kHz are boosted, while frequencies lower than 1kHz
are simultaneously cut. As the setting is decreased, frequencies
higher than 1kHz are cut, while frequencies lower than 1kHz are
simultaneously boosted. The graph on the next page illustrates the
frequency response of TILT EQ parameter settings.
Note:
Pressing and holding the S2 button while pressing
and releasing the Blue button sets the BASS, TREBLE
and TILT EQ parameters to +0.0dB.
TILT EQ AUDIO CONTROLS
AUDIO CONTROLS
(continued)
MAIN MENU
MODE ADJUST
AUDIO CONTROLS
SETUP
AUDIO CONTROLS
AUDIO CONTROLS
BASS +0.0dB
0.0dB
TILT EQ
+0.0dB
LOUDNESS OFF
BALANCE
<|>
FADER <|>
TILT EQ +0.0dB
–3.0 to +3.0dB MAIN MENU
MODE ADJUST
AUDIO CONTROLS
SETUP
AUDIO CONTROLS
AUDIO CONTROLS
BASS +0.0dB
0.0dB
TILT EQ
+0.0dB
LOUDNESS OFF
BALANCE
<|>
FADER <|>
LOUDNESS OFF
ON
OFF
LOUDNESS
ON, OFF
Controls the amount of low-frequency boost that is automatically
applied to the audio output connectors labeled Front L/R, Center
and Subwoofer. When set to ON, loudness compensation is
automatically applied based on volume level. As volume level
increases, the amount of boost automatically decreases. The
loudness contour is optimized for sources calibrated to THX-
reference levels. When set to OFF, no loudness compensation is
applied. The graph on the next page illustrates the frequency
response that is automatically applied when the LOUDNESS
parameter is set to ON and volume level is adjusted.
Note:
The graph on the next page displays LOUDNESS
parameter settings between –30dB and 0dB in 1dB
increments. The top-most line represents the curve
at –30dB.
LOUDNESS AUDIO CONTROLS