7
A
The angle of the footplate can be changed in a range from
minus 5° to plus 15° to the horizontal level. To put the angle
of the footplate in the requested position adjust the two
threaded pins (A) below the footplate using a 6 mm hexagon
key. Turn the pins in or out just the way needed to get the
requested angle of the footplate.
Caution:
Both pins must touch the leg rests when the
footrests are in a flip-down position.
7.4.
Armrest
The armrest can be put in a flip-up position for an easy transfer sideways. This also allows a
better access to the chair. (See picture 8).
A
8
10
9
B
The height of the armrests is fully adjustable in between a range of 14 cm/5.5” to 33 cm/13”;
the height of the armrest is measured from the upper edge of the seat cushion to the upper part
of the armrest.
!
Loosen the cylindrical screw on either side of the armrest joints using a 5 mm hexagon
key. (See picture 9).
!
Now push the connecting rod and the armrest joints along the backrest tube for the ideal
position.
!
Tighten the cylindrical screw on the right and left side.
The angle of the armrest is also adjustable.
!
For lifting the armrest in front turn the threaded pin in (B) using a 2,5 mm hexagon key.
Turn the pin clock wise further in the armrest joints. (See picture 10).
!
For lowering the armrest in front turn the threaded pin out (B) using a 2,5 mm hexagon
key. Turn the pin counter clock wise further out of the armrest joints. (See picture 10).
19
