Install Your
Natural-Fit Handrims
CAUTION:
1
Proper installation is critical to the performance of your handrims.
Failure to follow these instructions will void the product warranty.
2
3
Old Handrim
Tool Needed:
Phillips head screwdriver
•
Remove the Old Handrim
Using a phillips screwdriver, disassemble and remove the screws
that mount the handrim to the wheel.
•
| www.out-front.com | 480.833.1829
A Three Rivers Brand
A Three Rivers Brand
Hardware and Tools
Hardware Needed:
Screws (use existing screws for X-Core wheels)
Spacers
•
•
Natural-Fit Assembly
Set-up the Natural-Fit Assembly
Place the new oval component on a fl at surface with the rivet-nuts
(threaded holes) facing up.
Place the new concave shaped thumb guard on top of the oval com-
ponent (the wider edge faces up to make contact with your wheel).
Place your wheel (recessed hole for quick release facing down)
on top of the thumb guard and oval component. Make sure the
mounting holes on the wheel match up with the rivet-nut holes for
the oval component.
1.
2.
3.
1.
2.
3.
NOTE: IF YOUR MAG WHEEL HAS STAND-OFFS, BE CAREFUL
WHEN PLACING THE THUMB GUARD AROUND THE STAND-
OFFS. TO AVOID DAMAGING YOUR THUMB GUARD AND TO
ALLOW IT TO FIT PROPERLY, YOU MAY NEED TO BEND THE
STAND-OFFS IN OR REMOVE A SMALL AMOUNT OF PLASTIC
FROM THE OUTSIDE OF THE STAND-OFF OF YOUR WHEEL.
INS-RIV
