evr-green
™
Level
2 -
Network Charging Station For Public Applications
www.leviton.com/evrgreen • 1-877-338-7473 • [email protected]
Step 2 - Slide head assembly into body
Slide the head assembly into body far
enough to connect the wiring, then:
• Connect the rectangular connector
to the terminal block, ensuring it
is fully seated.
• Connect the circular connector to
the cable assembly and turn its outer
ring clockwise until snug.
Note:
The circular connector is
keyed and must be properly aligned.
When properly aligned, press firmly
to ensure it is fully seated. If the
connector is not fully seated, the outer
ring will not tighten.
• Align semi-circular key with key slot.
• Align tabs with tab slot.
• Insert connector until fully seated.
• rotate connector’s outer ring
clockwise until snug.
• Firmly slide head module all the
way into body.
• Check alignment of security screw holes.
• If necessary, press down on head
assembly to seat gaskets.
IMPORTANT:
Before securing
the head assembly (described next),
ensure that it powers up. When the
circuit is live and the head assembly is
plugged in, a sequence of power-up
messages will be displayed. If this is
not the case, check that the head
assembly’s connectors are properly
seated onto the terminal block.
When the head assembly
is connected (and the
circuit is live), you should
see a sequence of
power-up messages on the
charging station’s display.
6-3
Key slot
Key
Tabs
Tab slots
