Page 57
Settings
– IPSec Policy Setup
Policy Entry
Name
– In order to distinguish the tunnel, you have to give
“Tunnel” a name.
State Enable
– If set to
Enable
, this will allow the tunnel to
connect.
Traffic Binding
WAN port
– You can choose any WAN port to make the VPN
connection.
Session
– If you are using a multi-session PPPoE connection,
you can select which PPPoE session will create a VPN tunnel
between two sites.
Local Identity Type
– You can select how the router will identify
itself to the destination VPN site. There are three options to select
from:
IP address
– This allows the authentication by using its public
IP address.
Domain Name
– This allows the authentication by using a
domain name.
Distinguished Name
– This allows the authentication by using
a distinguished name such as an email address or alpha-
numeric characters.
Traffic Selector
Service
–
Protocol Type:
You can choose TCP, UDP, ICMP or
GRE protocol as your connection protocol. By default the protocol
type is “Any”.
Local Security Network
– These entries identify the private
network on this VPN gateway - the hosts of which can use the
LAN-to-LAN connection. You can choose a single IP address, the
subnet, or a selected IP range to make VPN LAN-to-LAN
connection.
Remote Security Network
– These entries identify the private
network on the remote peer VPN gateway whose hosts can use
the LAN-to-LAN connection. You can choose a single IP address,
the subnet, or a selected IP range to make VPN connection
Remote Security Gateway
– You can select either the remote
side by a domain name, a remote side IP address (WAN IP
address) or a distinguished name as your remote side security
gateway.