IES-0880 User Manual
Page 96
Autoedge:
1.
Command Mode: Interface mode
Logon to Configure Mode (Configure Terminal Mode).
Then logon to Interface mode.
fe1 means port 1.
The
switch_a(config-if)#
prompt will show on the screen.
switch_a(config)#interface fe1
switch_a(config-if )#
2.
Usage:
Use
spanning-tree autoedge
command to assist in automatic identification of the edge
port.
Use the
no spanning-tree autoedge
command to disable this feature.
3.
Command Syntax:
(no) spanning-tree autoedge
4.
Example:
The following example enables the
spanning-tree autoedge
of the interface fe1 (port 1):
switch_a(config)#interface fe1
switch_a(config-if )#spanning-tree autoedge
switch_a(config-if )#
Edgeport:
1.
Command Mode: Interface mode
Logon to Configure Mode (Configure Terminal Mode).
Then logon to Interface mode.
fe1 means port 1.
The
switch_a(config-if)#
prompt will show on the screen.
switch_a(config)#interface fe1
switch_a(config-if )#
2.
Usage:
Use
spanning-tree edgeport
command to set a port as an edge-port and to enable rapid
transitions.
Use the
no spanning-tree edgeport
command to set a port to its default state (not an
edge-port) and to disable rapid transitions.
3.
Command Syntax:
(no) spanning-tree edgeport
4.
Example:
The following example enables the
spanning-tree edgeport
of the interface fe1 (port 1):
switch_a(config)#interface fe1
