IES-0880 User Manual
Page 107
The
switch_a(config-if)#
prompt will show on the screen.
switch_a(config)#interface fe1
switch_a(config-if )#
2.
Usage:
Use this command to set the switching characteristics of the Layer-2 interface to trunk.
The all parameter indicates
parameter indicates that no VLAN ID is configured on this port. The add and remove
Use the no parameter to remove all VLAN IDs configured on this port.
3.
Command Syntax:
switchport trunk allowed vlan all
switchport trunk allowed vlan none
switchport trunk allowed vlan add VLANID
switchport trunk allowed vlan remove VLANID
switchport trunk allowed vlan except VLANID
no switchport trunk vlan
all Allow all VLANs to transmit and receive through the Layer-2 interface.
none Allow no VLANs to transmit and receive through the Layer-2 interface.
add Add a VLAN to transmit and receive through the Layer-2 interface.
remove Remove a VLAN from transmit and receive through the Layer-2 interface.
except All VLANs, except the VLAN for which the ID is specified, are part of its ports
member set.
VLANID <2-4094> The ID of the VLAN or VLANs that will be added to, or removed from,
the Layer-2 interface. A single VLAN, VLAN range, or VLAN list can be set.
For a VLAN range, specify two VLAN numbers: lowest, then highest number in the range,
separated by a hyphen.
For a VLAN list, specify the VLAN numbers separated by commas.
4.
Example:
The following example specifies to
add
the interface fe1 (port 1) to VLANID (
2
):
switch_a(config)#interface fe1
switch_a(config-if )#switchport trunk allowed vlan add 2
switch_a(config-if )#
Port Based VLAN
Switchport portbase add/remove vlan:
1.
Command Mode: Interface mode
Logon to Configure Mode (Configure Terminal Mode).
Then logon to Interface mode.
fe1 means port 1.
The
switch_a(config-if)#
prompt will show on the screen.
switch_a(config)#interface fe1
switch_a(config-if )#
