IES-0880 User Manual
Page 129
(VLAN) when no multicast routing protocol is configured in the subnet (VLAN). When
enabled, the IGMP Snooping querier sends out periodic IGMP queries for all interfaces on
that VLAN.
Use the
no ip igmp snooping querier
command to disable IGMP querier configuration.
3.
Command Syntax:
(no) ip igmp snooping querier
4.
Example:
The following example enables IGMP snooping querier:
switch_a(config)# ip igmp snooping querier
switch_a(config)#
IGMP mode:
Passive:
1.
Command Mode: Configure mode
Logon to Configure Mode (Configure Terminal Mode).
The
switch_a(config)#
prompt will show on the screen.
switch_a(config)#
2.
Usage:
Use
ip igmp snooping
command to enable IGMP Snooping. This command is given in the
Global Config mode. IGMP Snooping is enabled at the switch level.
Use the
no ip igmp snooping
command to globally disable IGMP Snooping.
3.
Command Syntax:
(no) ip igmp snooping enable
4.
Example:
The following example enables IGMP snooping on the switch:
switch_a(config)# ip igmp snooping enable
switch_a(config)#
IGMP version:
1.
Command Mode: Interface mode
Logon to Configure Mode (Configure Terminal Mode).
Then logon to Interface mode.
vlan1.1 means vlan 1.
The
switch_a(config-if)#
prompt will show on the screen.
switch_a(config)#interface vlan1.1
switch_a(config-if )#
2.
Usage:
