90
Discovery Protocol (LLDP) packet before discarding it. (Default: 4 times)
Tx Delay:
The specifies the delay between successive LLDP frame transmissions
initiated by value/status changes in the LLDP local systems MIB.
(Default: 2 secs)
Tx Reinit:
The specifies the minimum time an LLDP port waits before reinitializing
LLDPtransmission. (Default: 2 secs)
Notification Interval:
A network management application can periodically check the Switch
MIB todetect any missed change notification traps. Refer to IEEE
802.1AB-2005 or later for more information. (Default: 5 secs)
Mode:
To enable or disable the LLDP mode per port. There are four type
includes Disable, Tx_Rx, Tx only and Rx only
Port Descr:
To evoke the outbound LLDP advertisements, includes an
alphanumeric string describing the port.
Sys Name:
To evoke the outbound LLDP advertisements, includes the system’s
assigned name
Sys Descr:
To evoke outbound LLDP advertisements, includes an alphanumeric
string describing the full name and version identification for the system’s
hardware type, software version, and networking application.
Sys Capa:
To evoke outbound advertisements, includes a bitmask of system
capabilities (device functions) that are supported. Also includes
information on whether the capabilities are enabled.
Mgmt Addr:
To evoke outbound advertisements, includes information on
management address. you can use to include a specific IP address in
the outbound LLDP advertisements for specific ports
Notification:
To evoke outbound advertisements, includes information on Notification.
Summary of Contents for FGP-1072
