Configuration and diagnostics software - Sensor Studio
Leuze electronic
DCR 50
16
NOTICE
The MA-CR modular adapter unit with spring terminals and plug connector for connecting the
device, as well as a D-SUB 9-pin socket for connecting an RS 232 interconnection cable, is
available as an accessory (see chapter 13 "Order guide and accessories").
The MA-CR modular adapter unit requires 10 V … 30 V DC as external voltage supply, which
can be fed in via spring terminals. Alternatively, 5 V DC can be fed via the 6-pin plug connector
of the DCR 50 using a 150 mm long interconnection cable with 12-pin Molex terminal strip.
6.3
Starting the Sensor Studio configuration software
Prerequisites:
• The device has been mounted (see chapter 4 "Mounting") and connected (see chapter 5 "Electrical
connection") correctly.
• The device is connected to the PC via the RS 232 interface (see chapter 6.2.4 "Connecting device to
• The
Sensor Studio
configuration software is installed on the PC (see chapter 6.2 "Installing Sensor Stu-
Ä
Start the
Sensor Studio
configuration software by double-clicking the
Sensor Studio
icon (
).
The
mode selection
of the
Project Wizard
is displayed.
Ä
Select the
Device selection without communication connection (offline)
configuration mode and
click on [Next].
The
Project Wizard
displays the
Device selection
list of the configurable devices.
Fig. 6.1:
Device selection for scan engine DCR 50
