Mounting and commissioning
Leuze electronic GmbH & Co. KG
CSL 505
25
4.2.2
Teach event for devices after 40/2017 (firmware version starting with V2.22)
The firmware version is displayed in the lower right area of the configuration software if the light
curtain is connected to the software, see Figure 3:!
With this firmware version, the "Power-up teach delay" parameter
–
stored in the firmware as
$(AutoCalDelay)
–
is set to the following value at the factory:
$(AutoCalDelay) = 254
Execution of teach event:
1.
On the receiver, switch pin 2 (Q1_RX) to +24 VDC.
2.
Switch on the device by connecting pin 1 to +24 VDC and pin 3 to GND.
3.
The LEDs indicate a successful teach as follows:
- LED 1: Continuous light
- LED 2: Double flashing.
4.
Switch off the device.
5.
On the receiver, disconnect pin 2 (Q1_RX) from +24 VDC.
4.2.3
Optional teach-in adapter
If multiple light curtains are installed at the same time, teach-in adapter PA1/XTSX-M12 (part
number: 50124709) simplifies the teach event enormously. It is connected between receiver and
connection cable.
Connection
cable
Adapter cable
(Part no.
50116738)
Teach-in adapter
(Part no. 50124709)
Adapter cable
(Part no.
50107276)
Receiver
M8 cable
4-pin,
female
M8 4-pin, male
to M12 4-pin,
female
PA1/XTSX-M12
M12 4-pin,
male to M8 4-
pin, female
M8 socket
4-pin, male
Pressing the button on the adapter switches the supply voltage to pin 2.
After the teach event, the adapter is removed and the device plugged directly back into the
connection cable.