Leuze electronic ODS 9, Original Operating Instructions

Page: 16 / 72

Device description
Leuze electronic ODS 9 16
3.4.1 Input menu
The function of the switching input on pin 5 is set in the Input menu.
NOTICE
The Input menu is only available for sensors with multifunction input on pin 5 (ODS9…/ LAK -
…).
Level 1 Level 2 Level 3 Description Default
Input Input Mode Function of the switching input on pin 5 if the supply voltage
is applied.
No Function No input function active
Teach Teach analog output and switching out-
put X
Deactivation Switch off laser transmitter with +24 V
on the switching input
Activation Switch on laser transmitter with +24 V
on the switching input
Trigger rising The measurement value is only updated
and output by an edge on input PIN 5.
Trigger falling
Important : Activation or deactivation using IO-Link commands or process data (PDOut) only has an effect
if neither Deactivation nor Activation is set as the input function.
3.4.2 Output_SSC1 menu
The switching behavior of switching output SSC1 is set to pin 4 in the Output_SSC1 menu.
NOTICE
Designation "SSC" corresponds to designation "Q" previously used for switching outputs.
Level 1 Level 2 Level 3 Description Default
Output_SSC1 SSC1_SP1_dist. Upper switching point Depending on the
device range:
• 100 mm: 75 mm
• 200 mm: 175 mm
• 450 mm: 250 mm
• 650 mm: 350 mm
SSC1_SP2_near Lower switching point 50 mm
Notice : For the limit values of the measurement range for your sensor, see chapter 12
"Technical data".
SSC1_Hysteresis Hysteresis ODS9L1.8…:
10 mm
SSC1_Logic Behavior of the switching output if an
object is within the taught/configured
switching distance.
• High active: switching output ac-
tive (high)
• Low active: switching output in-
active (low)
High active