leptron Precision RDASS, Manual

Page: 8 / 36

5
2.3 Bind Remote Control to Syma X5
Condition(s):
1. Syma X5 with battery installed and camera removed
Standard(s):
1. Properly bind the remote control to the aircraft
2. Avoid cross-binding with any adjacent aircraft
Crew Actions:
Pilot on the Controls:
1. Turn on the remote control power switch
2. Turn on the Syma X5 power switch
3. Announce “Clear on the Flight Line”
Remote Control Operator (RCO):
1. Assist Pilot on the Controls by confirming that no other
flight crew is attempting to bind a remote control to the
Syma X5 in use
Procedure:
The Pilot on the Controls will turn on the remote control first.
Then turn on the Syma X5. Place the Syma X5 right side up on a
level surface promptly. The Syma’s computer determines level
shortly after power is applied and if the pilot takes too long to
set down the Syma X5, the aircraft will not fly properly. The
lights on the quadcopter will blink slowly. Announce “Clear on
the Flight Line” and wait for any responses. When the Visual
Observer confirms that the flight line is clear, apply full throttle
and then replace the throttle to the full-down position. This
binds the aircraft to the remote and the Syma X5 is ready to fly.
If two remote controls attempt to bind
simultaneously, the aircraft can become
uncontrollable.
CAUTION
To Bind: Move Throttle
Full-Up then Full-Down