Operation
Communicating via the CAN gateway function
Establishing communication using the system bus configurator
8
72
LDCDS−EL100 EN 8.0
9. If you are positive that your communication settings are correct, confirm the
message by clicking
Yes
, otherwise click
No
.
If you have clicked "Yes", the communication module starts searching the bus for
connected devices. If the communication module was able to successfully
communicate with the connected devices, the "Device state" field will list the system
bus node addresses of the found devices.
If the communication module should not be able to communicate with the nodes, an
error message will be displayed. The communication module itself is listed with its CAN
address. However, the data telegrams regarding communication with the
communication module are not visible on the CAN bus.
EL100−040
In the case of successful configuration, the Lenze tools (e.g. GDC, Engineer, ...) are able to
communicate via the gateway function.
