44
17.3 Important advice on the push-pull control:
You can choose the speed of the push-pull train freely. If you set
the speed to 0 while the train is stopping at an end point, the
train will only start moving again when the stopping time has
elapsed and you increase the speed.
If you wish to interrupt the stopping time prematurely, simply set
the stopping time in CV54 to 0. The train will immediately start
moving. As soon as the entire train has left the stopping section,
set CV54 again to the desired value. In the same way, you can
also extend the stopping time while in push-pull operation.
18
Resetting the decoder
If you wish to reset all the decoder CVs to their default settings,
enter value 33 in CV8. Doing so does not affect the
characteristic speed line; however, please note that Bit 5 is
deleted in CV29 which means that the decoder is set to using
the default speed line.
The CVs of a connected S.U.S.I. module are not reset!
