Lenovo ThinkCentre 41N5626, User Manual

Page: 22 / 72

Securing a disc in a vertically mounted drive
To load a disc into a vertically mounted drive, do the following:
Note: The drive tray design might be different than shown (varies by manufacturer).
1. Press the Eject/Load button.
2. Insert the disc into the tray and make sure it is placed securely behind the vertical mounting tabs
1
.
3.
Close the loading tray by pressing the
Eject/Load
button, or by gently pushing the tray in.
Note: 8 cm and
″
credit card CDs
″
cannot be used in vertically mounted drives without a special adapter.
Manually ejecting a disc
If you press the Eject/Load button and the tray does not slide out, turn off the computer. Straighten a
large paper clip to form a tool, as shown in the illustration. The straightened end must extend at least 45
mm (1.8 in.). Insert the extended end into the manual-eject hole on the front of the drive (see “Drive
controls and connectors” on page 1-3). Push the paper clip into the hole until the tray opens. Gently pull
out the tray until you can remove the disc.
45 mm
1.8 in
Using media
Your Super Multi-Burner Drive can record onto the following types of media:
v DVD-RAM : Write many times media that is optimized for data storage. DVD-RAM media can be read
in most modern DVD-ROM drives, but cannot be read by some set-top DVD players.
v
DVD-R : Write once media that has the best compatibility with set-top DVD players and computers.
DVD-R media can be read in almost any type of DVD-ROM drive or DVD player.
v DVD-R DL
: Write once media that has a higher capacity (8.5 GB) than ordinary DVD-R media. DVD-R
DL media can be read in many DVD-ROM drives and DVD players but is not as compatible as the
lower capacity DVD-R media.
v
DVD-RW : Write many times media that can be read in most set-top DVD players and almost all
computers. Some older DVD players might not be able to read this media.
3-2
ThinkCentre and Lenovo Super Multi-Burner Drive (Serial ATA) User’s Guide