Lenovo ThinkAgile HX Series, User Manual

Page: 72 / 104

If you are instructed to return the old LOM adapter, follow all packaging instructions and use any packaging
materials that are provided.
Install the LOM adapter
Use this information to install the LOM adapter.
“ Read the
installation
Guidelines” on
page 43
“ Power off
the server
for this task”
on page 35
“ ATTENTION:
Static Sensitive Device
Ground package before opening”
on page 45
Before installing the LOM adapter:
1. If riser 1 assembly is installed, remove it to access the LOM adapter slot.
2. Touch the static-protective package that contains the new LOM adapter to any unpainted surface on the
outside of the server. Then, take the new LOM adapter out of the package and place it on a static-
protective surface.
To install the LOM adapter, complete the following steps:
Figure 34. LOM adapter installation
Step 1. Insert the LOM adapter into the rear of the chassis at an angle as shown.
Step 2. Lower the LOM adapter and slide it to the rear of the chassis until the LOM adapter stops.
Step 3. Push the LOM adapter as shown to insert it into the connector on the system board.
Step 4. Tighten the thumbscrew to secure the LOM adapter.
After installing the LOM adapter:
1. Replace the top cover.
2. Install the node back into the rack and reconnect all cables.
3. Power on the node.
4. Exit maintenance mode.
5. Verify that the NIC is replaced successfully:
• The amber warning light on the node front panel is off.
68
User Guide for ThinkAgile HX1321 Node ThinkAgile HX3321 Node