Lenovo ThinkAgile HX Series, User Manual

Page: 22 / 104

Used to attach a high-performance monitor, a direct-drive monitor, or other devices that use a VGA
connector.
9 XClarity Controller network connector
Used to attach an Ethernet cable to manage the system using XClarity Controller.
10 Ethernet connectors on LOM adapter (available on some models)
The LOM adapter provides two or four extra Ethernet connectors for network connections.
The leftmost Ethernet connector on the LOM adapter can be set as XClarity Controller network connector. To
set the Ethernet connector as XClarity Controller network connector, start Setup utility, go to
BMC Settings
➙ Network Settings ➙ Network Interface Port and select Shared . Then, go to Shared NIC on and select
PHY Card .
Rear view of server models with two PCIe slots
The following illustration shows the rear view of the server models with two PCIe slots. Depending on the
model, your server might look slightly different from the illustration below.
Figure 9. Rear view of server models with two PCIe slots
Table 5. Components on the rear of the server
1
PCIe slot 1 on riser 1 assembly
2
PCIe slot 2 on riser 1 assembly
3
Power supply 1
4
Power supply 2 (available on some models)
5
NMI button
6
USB 3.0 connectors
7
VGA connector
8
XClarity Controller network connector
9
Ethernet connectors on LOM adapter (available on
some models)
1 2 PCIe slots on riser 1 assembly
Your server supports three types of riser cards for riser 1 assembly.
• Type 1
– Slot 1: PCIe x16 (x8, x4, x1), low-profile
– Slot 2: PCIe x16 (x16, x8, x4, x1), full-height, half-length
• Type 2
– Slot 1: ML2 x8 (x8, x4, x1), low-profile
– Slot 2: PCIe x16 (x16, x8, x4, x1), full-height, half-length
• Type 3
– Slot 1: ML2 x16 (x16, x8, x4, x1), low-profile
18
User Guide for ThinkAgile HX1321 Node ThinkAgile HX3321 Node