Lenovo 7515L2U, Hardware Maintenance Manual

Page: 71 / 292

Diagnostic error code FRU/Action
015-000-XXX
USB (Universal Serial Bus) port Interface
Test Passed
No action
015-001-XXX
USB port Presence
1. Remove USB device(s) and re-test
2.
System board
015-002-XXX
USB port Timeout
1. Remove USB device(s) and re-test
2. System board
015-015-XXX
USB port External Loopback failure
1. Remove USB device(s) and re-test
2. System board
015-027-XXX
USB port Configuration/Setup error
1. Flash the system. See “Updating
(flashing) BIOS from a disc” on page
278
2.
System board
015-032-XXX
USB port Device Controller failure
System board
015-034-XXX
USB port buffer
allocation failure
1.
Reboot the system
2. Flash the system and re-test. See
“Updating (flashing) BIOS from a disc”
on page 278
3. Run memory test
4. System board
015-035-XXX
USB port Reset condition detected
1. Remove USB device(s) and re-test
2. System board
015-036-XXX
USB port Register error
System board
015-040-XXX
USB port IRQ failure
1.
Run setup and check for conflicts
2.
Flash the system. See “Updating
(flashing) BIOS from a disc” on page 278
3. System board
015-195-XXX
USB port Test aborted by user
Information only
Re-start the test, if necessary
015-196-XXX
USB port test halt, error threshold exceeded
1. Press F3 to review the log file
2. Re-start the test to reset the log file
015-197-XXX
USB port test warning
1. Make sure the component that is called
out is connected and/or enabled. See
Chapter 6, “Using the Setup Utility
program,” on page 51
2.
Re-run test
3. Replace the component that is called out
in warning statement
4. Replace the component under test
Chapter 7. Symptom-to-FRU index
65