Lenovo 7515L2U, Hardware Maintenance Manual

Page: 119 / 292

5. Remove the retaining bracket from the failing diskette drive or card reader and
install it on a new diskette drive or card reader.
6. Slide the new diskette drive or card reader into the drive bay until it snaps into
position.
7. Connect the signal cable and the power cable to the new diskette drive or card
reader.
8. Reinstall the front bezel.
What to do next:
v To work with another piece of hardware, go to the appropriate section.
v
To complete the replacement, go to “Completing the FRU replacement” on
page 120.
Replacing the front fan assembly
Attention
Do not open your computer or attempt any repair before reading and understanding the
“Important safety information” in the
ThinkCentre Safety and Warranty Guide that came with
your computer. To obtain a copy of the ThinkCentre Safety and Warranty Guide , go to:
http://www.lenovo.com/support
This section provides instructions on how to replace the front fan assembly.
Note: Depending on model type, your computer might have a front fan assembly
installed.
To replace the front fan assembly, do the following:
1. Remove the computer cover. See “Removing the computer cover” on page 86.
2. Remove the front bezel. See “Removing and reinstalling the front bezel” on
page 89.
3. Disconnect the front fan assembly cable from the power fan connector on the
system board. See “Locating parts on the system board” on page 89.
Figure 30. Retaining bracket for diskette drive or card reader
Chapter 8. Replacing FRUs - Tamdhu
113