Lenovo 2746AD4 - ThinkPad SL500 2746, Supplementary Manual

Page: 20 / 82

Message Solution
8207: NO ROM
BASIC This message occurs on some systems when no bootable device
can be detected.
8318: S.M.A.R.T.
Capable but
Command Failed The BIOS tried to send a S.M.A.R.T. message to a hard disk,
but the command transaction failed. This message can be
reported by an ATAPI device using the S.M.A.R.T. error
reporting standard.S.M.A.R.T. failure messages may indicate
the need to replace the hard disk.
8319: S.M.A.R.T.
Command Failed The BIOS tried to send a S.M.A.R.T. message to a hard disk,
but the command transaction failed. This message can be
reported by an ATAPI device using the S.M.A.R.T. error
reporting standard.S.M.A.R.T. failure messages may indicate
the need to replace the hard disk.
831A: S.M.A.R.T.
Status BAD, Backup
and Replace A S.M.A.R.T. capable hard disk sends this message when it
detects an imminent failure. This message can be reported by
an ATAPI device using the S.M.A.R.T. error reporting standard.
S.M.A.R.T. failure messages may indicate the need to replace
the hard disk.
831B: S.M.A.R.T.
Capable and Status
BAD A S.M.A.R.T. capable hard disk sends this message when it
detects an imminent failure. This message can be reported by
an ATAPI device using the S.M.A.R.T. error reporting standard.
S.M.A.R.T. failure messages may indicate the need to replace
the hard disk.
8400: BootSector
Write !! The BIOS has detected software attempting to write to a
drive’s boot sector. This is flagged as possible virus activity.
This message will only be displayed if Virus Detection is
enabled in AMIBIOS setup.
8401: VIRUS:
Continue (Y/N)? If the BIOS detects possible virus activity, it will prompt the
user. This message will only be displayed if Virus Detection is
enabled in AMIBIOS setup.
8500: DMA-1 Error Error initializing primary DMA controller. This is a fatal error,
often indicating a problem with system hardware.
8501: DMA-2 Error Error initializing secondary DMA controller. This is a fatal
error, often indicating a problem with system hardware.
8502: DMA
Controller Error POST error while trying to initialize the DMA controller. This
is a fatal error, often indicating a problem with system
hardware.
8503: Checking
NVRAM..Update
Failed BIOS could not write to the NVRAM block. This message
appears when the FLASH part is write-protected or if there is
no FLASH part (System uses a PROM or EPROM).
12
ThinkPad
®
SL300, SL400, and SL500 Service and Troubleshooting Guide