Lenovo 10152/F0AG, Hardware Maintenance Manual

Page: 94 / 118

Replacing the integrated camera
Attention
Do not open your computer or attempt any repair before reading and understanding the Important safety
information in the
Safety, Warranty, and Setup Guide
that came with your computer. To obtain a copy of the
Safety, Warranty, and Setup Guide
, go to:
http://www.lenovo.com/support
This section provides instructions on how to replace the integrated camera.
Note: The integrated camera is available only in some models.
To replace the integrated camera, do the following:
1. Remove all media from the drives and turn off all attached devices and the computer. Then, disconnect
all power cords from electrical outlets and disconnect all cables that are connected to the computer.
2. Place a soft, clean towel or cloth on the desk or other at surface. Hold the sides of your computer and
gently lay it down so that the screen is against the surface and the cover is facing up.
3. Remove the computer cover. See Removing the computer cover on page 71.
4. Remove the VESA mount bracket. See Removing and reinstalling the VESA mount bracket on page 71.
5. Locate the integrated camera in the computer. See Locating major FRUs and CRUs on page 63.
6. Remove the system board shield. See Removing and reinstalling the system board shield on page 76.
7. Note the routing of the integrated camera cable, and then disconnect the cable from the system board.
See Locating parts on the system board on page 66.
8. Remove the two screws that secure the integrated camera to the front bezel to remove the integrated
camera from the computer.
Figure 31. Removing the integrated camera
9. To reinstall the integrated camera, position the new integrated camera and align the two screw holes in
the new integrated camera with those in the front bezel.
10. Install the two screws to secure the new integrated camera to the front bezel.
88
Lenovo S710 All-In-OneHardware Maintenance Manual