Lenovo 10152/F0AG, Hardware Maintenance Manual

Page: 77 / 118

Removing the computer cover
Attention
Do not open your computer or attempt any repair before reading and understanding the Important safety
information in the
Safety, Warranty, and Setup Guide
that came with your computer. To obtain a copy of the
Safety, Warranty, and Setup Guide
, go to:
http://www.lenovo.com/support
This section provides instructions on how to remove the computer cover.
CAUTION:
Turn off the computer and wait three to ve minutes to let the computer cool before removing the
computer cover.
To remove the computer cover, do the following:
1. Remove all media from the drives and turn off all attached devices and the computer. Then, disconnect
all power cords from electrical outlets and disconnect all cables that are connected to the computer.
2. Place a soft, clean towel or cloth on the desk or other at surface. Hold the sides of your computer and
gently lay it down so that the screen is against the surface and the cover is facing up.
3. Remove any locking device that secures the computer cover, such as an integrated cable lock.
4. Remove the system stand. See Removing and reinstalling the system stand on page 68.
5. Loosen the two screws
1
at the bottom of the computer. Put your index nger or thumb in the nger
slot
2
, and then lift the computer cover up to remove it from the computer.
Figure 9. Removing the computer cover
Removing and reinstalling the VESA mount bracket
Attention
Do not open your computer or attempt any repair before reading and understanding the Important safety
information in the
Safety, Warranty, and Setup Guide
that came with your computer. To obtain a copy of the
Safety, Warranty, and Setup Guide
, go to:
http://www.lenovo.com/support
Chapter 9
.
Replacing FRUs
71