NOTE: DIAGRAMS AND ILLUSTRATIONS ARE REPRESENTATIVE AND ARE NOT DRAWN TO SCALE.
34
Min. 1"
(25 mm)
Min. 3"
(76 mm)
Top Nailing Flange*
Bottom Nailing Flange*
Sp
ac
er
Combustible material NOT ALLOWED
BELOW THIS POINT on face of unit.
Lip on Top Nailing Flange
Bottom edge of Fiber Board abuts lip.
Combustible Wall Finish Material
Top Non-Combustible
Fiber Board
(provided
with fireplace)
Wall
Stud
*
*
Insulation and combustible
material NOT ALLOWED in
clearance zones around vent
components.
*
Header
Header
Cleanface Finish
Surround/Bezel Finish
*Position of Top
and Bottom Nailing
Flanges depends on
type and thickness
of wall finish. See
“UNIT NAILING
FLANGES” section.
For Surround finish,
cut Top Fiber Board
to height of installed
Top Spacers.
Combustible
material
NOT ALLOWED
BELOW THIS
POINT on
face of unit.
Side Non-Combustible
Fiber Board
(one of two;
provided with fireplace)
Minimum 6"
Vertical Vent
and 90° Elbow
Min. 1"
(25 mm)
Min. 3"
(76 mm)
Sp
ac
er
Wall
Stud
*
*
Minimum 6"
Vertical Vent
and 90° Elbow
Min. 1"
(25 mm)
Min. 3"
(76 mm)
Top Nailing Flange*
Bottom Nailing Flange*
Sp
ac
er
Combustible material NOT ALLOWED
BELOW THIS POINT on face of unit.
Lip on Top Nailing Flange
Bottom edge of Fiber Board abuts lip.
Combustible Wall Finish Material
Top Non-Combustible
Fiber Board
(provided
with fireplace)
Wall
Stud
*
*
Insulation and combustible
material NOT ALLOWED in
clearance zones around vent
components.
*
Header
Header
Cleanface Finish
Surround/Bezel Finish
*Position of Top
and Bottom Nailing
Flanges depends on
type and thickness
of wall finish. See
“UNIT NAILING
FLANGES” section.
For Surround finish,
cut Top Fiber Board
to height of installed
Top Spacers.
Combustible
material
NOT ALLOWED
BELOW THIS
POINT on
face of unit.
Side Non-Combustible
Fiber Board
(one of two;
provided with fireplace)
Minimum 6"
Vertical Vent
and 90° Elbow
Min. 1"
(25 mm)
Min. 3"
(76 mm)
Sp
ac
er
Wall
Stud
*
*
Minimum 6"
Vertical Vent
and 90° Elbow
fINISh AND TRIM
(CONTINUED)
Figure 34-2: Removing Filler/Angle Brackets
(When installing optional Surround only)
Removing filler/Angle Brackets
(when installing Surround)
IMPORTANT!
• Remove filler brackets when installing Surround ONLy.
Do NOT remove filler brackets for Cleanface Finish, as they
are required for proper combustion.
• Nailing flanges were omitted in illustration for clarity only
(it is NOT necessary to remove nailing flanges when
removing filler brackets).
Figure 34-1
Surround finish
Cleanface finish
LENNOX HEARTH PRODUCTS • ELITE LINEAR VIEW DIRECT-VENT GAS FIREPLACE (MODELS LDV42, LDV54) • INSTALLATION INSTRUCTIONS
Figure 34-3: Installing Optional Surround
