www.lennoxhearthproducts.com
126544-01A
5
LOCAL CODES
UNPACKING
Install and use fireplace with care. Follow all
local codes. In the absence of local codes,
use the latest edition of
The National Fuel
Gas Code ANSI Z223.1/NFPA 54*.
*Available from:
American National Standards Institute, Inc.
1430 Broadway
New York, NY 10018
National Fire Protection Association, Inc.
Batterymarch Park
Quincy, MA 02269
Note: Where listed vented decorative logs
are required, thermostat operation is not
permitted.
State of Massachusetts:
The installation
must be made by a licensed plumber or
gas fitter in the Commonwealth of Mas
-
sachusetts.
Sellers of unvented propane or natural
gas-fired supplemental room heaters shall
provide to each purchaser a copy of 527
CMR 30 upon sale of the unit.
Vent-free gas products are prohibited for
bedroom and bathroom installation in the
Commonwealth of Massachusetts.
CAUTION: Do not remove the
data plates attached to the heater
base assembly. The data plates
contain important warranty and
safety information.
1. With utility knife, cut the carton all the way
around above the staples on the bottom
tray. Lift the carton off the heater. Remove
packing.
Note: The hood and two smooth panels
are located in the packing on the right hand
side of the heater front. Lift the heater off
the bottom tray.
2. Locate two screws above top corners of
the fireplace screen. Remove and discard
these screws. Push the bottom corners of
the screen in and release. The screen will
pop out at the bottom. Grasp the bottom
of the screen, lift the screen up and pull
out to remove.
3. Remove protective packaging applied to
logs, log base assembly, and fireplace.
4. Remove fireplace hood and two smooth
panels from carton inserts.
5. Check all items for any shipping damage.
If damaged, promptly inform dealer where
you bought fireplace.
PRODUCT FEATURES
OPERATION
This vent-free fireplace is clean burning. It
requires no outside venting. There is no heat
loss out a vent or up a chimney. Heat is gen-
erated by both realistic flames and glowing
embers. When used without the blower, the
fireplace requires no electricity making it ideal
for emergency backup heat.
SAFETY DEVICE
This fireplace has a pilot with an Oxygen
Depletion Sensing (ODS) safety shutoff
system. The ODS/pilot is a required feature
for vent-free room heaters. The ODS/pilot
system shuts off the fireplace if there is not
enough fresh air.
ELECTRONIC IGNITION SYSTEM
This heater has an electronic ignitor to light
the fireplace's fuel supply.
BLOWER ASSEMBLY
This fireplace includes a blower assembly. The
blower operates thermostatically and features
a variable speed control. The blower circulates
heated air from the fireplace into the room.
f i r e - p a r t s . c o m
